Kitchen range hood installation in Ottawa — FixItAll Handyman Services

Need a new kitchen range hood installed?
I remove the old unit (if present), mount the new hood securely, and make sure it sits straight and tight to the cabinet or wall.
If there is an existing duct, I connect and seal the vent properly so airflow is strong and leaks are minimized.
For recirculating models, I install the hood neatly and confirm the setup is correct for that style.
I finish with clean sealing and a tidy look around the unit.
The result is reliable ventilation and a kitchen that looks more finished and modern.
Service is available across Ottawa and nearby areas.

What’s included: installation of under-cabinet, wall-mounted, and recirculating range hoods; secure fastening into solid structure; careful alignment/leveling; connection to an existing duct (when present); and neat sealing/finishing around the hood.

When this service helps: your old hood is noisy, weak, or outdated; the fan isn’t clearing smoke/odours well; you’re upgrading during a kitchen refresh; or you want a cleaner look with a properly mounted unit and solid ventilation connection.

Process & result check: I confirm the mounting points, install the hood, then check stability, alignment, and clearances. If a duct connection exists, I verify it’s seated and sealed and that airflow direction is correct. I also do a basic operational check (fan speeds and light function) and leave the area clean.

Important limitations: I connect to an existing vent/duct path when available, but I do not cut new exterior wall/roof openings or run new ductwork through finished ceilings/walls as part of a standard install. I also do not perform licensed electrical work (new circuits, panel work) or any gas work. If the job requires new wiring, new vent penetration, or code-required trades, I will advise you to use a licensed electrician/HVAC contractor.

Work is performed by FixItAll Handyman Services in Ottawa. I’m a fully registered and insured sole proprietor in Ontario, and I focus on neat, careful installations. Before starting, I confirm the scope on-site (model type, mounting, and vent situation) and keep the job transparent—no changes without your approval.