Curtain rod installation in Ottawa — FixItAll Handyman Services

Curtain rods pulling out of drywall, hanging crooked, or not strong enough for heavy curtains? I install curtain rods securely so brackets don’t loosen, the rod sits perfectly level, and the curtains glide smoothly. I mount single, double, and blackout rods and set the correct height and width for a balanced look around the window. I use the right anchors and fasteners for drywall, wood, or tile, and I reinforce weak fixing points when needed. After mounting, I fine-tune alignment, tighten all hardware, and check operation so the setup feels solid and looks clean. You get a clear scope and a flat-rate quote confirmed before work begins. I serve Ottawa, Nepean, Barrhaven, Kanata, and Orléans.

What’s included: bracket layout and leveling, correct anchor selection, secure mounting, reinforcement of pulled-out or weak fixings, final tightening, and a full operation check so curtains open and close smoothly.

When this service is a good fit: rods are sagging, spinning, or pulling away from the wall; curtains are heavy (blackout or layered); the rod is off-center or crooked; or you’re installing new window coverings and want a neat, durable setup.

How the installation goes: I confirm the wall material, mark bracket positions, drill with the correct bit, set anchors/fasteners, level and mount brackets, install the rod, then re-check level and spacing. I finish by tightening all hardware and testing curtain movement for smooth, quiet operation.

Not included / limitations: supplying curtain rods, brackets, or curtains is not included unless agreed in advance. If the wall surface is damaged, crumbling, or previously patched, I will explain reinforcement options before proceeding. Any additional materials or specialty anchors are confirmed before purchase/installation.

Who’s doing the work: FixItAll Handyman Services (Ruslan). I’m a fully registered and insured sole proprietor in Ontario, focused on secure mounting, clean alignment, and tidy finishing. Scope and a flat-rate quote are confirmed before work begins.